The technical condition of the power system can be determined by measuring the fuel consumption and comparing it with control, and fuel consumption on the content of carbon monoxide in the exhaust gases, test instrumentation system power supply in special facilities. Leaks fuel lines, carburetor (if available), fuel pump, fuel tank, muffler checked by inspection. When disassembling the carbs recommended to be careful not to damage gaskets and parts. Service fuel filter is as follows. Of coarse filter should be periodically drained sludge of mud and water and rinse the filter element in gasoline or acetone, followed by blowing with compressed air .. Disassemble the filter element is not recommended. Air cleaner service is changing the oil in an oil bath, rinsing the filter element and check the filter to the engine mount. The filter element of the inertial-oil filter is washed, then dipped in pure oil, take out, give the oil to drain and put in place. The filter body is thoroughly clean the inside from dirt, oil and sludge. In the bath pour oil filter for the engine (fresh or spent). To check the fuel pump the easiest way to disconnect the fuel pump inlet, wet your finger close the inlet and manually several times to pump fuel. Slight suction finger to the hole indicates the serviceability of the pump.
No comments:
Post a Comment