Soundproofing car

Engine noise, the noise of wheels, drive cars and counterclaims, the bad weather - all around the car sounds tend to penetrate the interior of your car and break the enjoyment of movement. You can include loud music or the radio, drowning out background noise, but not be better to try to improve soundproofing your car? Even in the new foreign car can significantly reduce noise. Additional insulation will significantly reduce the noise in the cabin, which is suitable not only music lovers. If the car is new, the situation is much simpler - no need to pre-cleaning the exterior and interior from dust and dirt, and various crumbs accumulating under rugs and behind the seats. Soundproofing a car consists of two parts - works to improve the lining (reducing body vibration caused by engine and road noise), as well as work on the sound insulation (additional installation of sound-insulating material for purposes of repayment of high-frequency noise and low frequency sounds). Typically, insulating materials are glued onto the vibration isolation, also providing an additional improvement of thermal insulation. The main areas on which you can conduct the work on noise reduction are the doors, the roof, you may want to improve the insulating characteristics of the floor, trunk, hood space (its sound insulation reduces noise as the engine, still in the street), the wings of the car body, the rear shelf. To reduce noise from rain and other external sources are additional ceiling "layer". The interior will be much quieter during the idle engine if you install the hood lining. And the road noise from the rear wheel arches and boot floor muted insulating mats cargo compartment. In all cases, without exception, you must first remove neotverzhdaemoe corrosion-resistant coating (such as white spirit, so as not to damage the paint or primer). No soundproof materials can not be installed on top of even a thin layer of anticorrosive. This caveat applies only to anti-corrosive compositions, preserving in the process of operation of certain plasticity and toughness. Basically, they are made for oil-oil or bitumen-based. Epoxy anticorrosive in working condition have a strong consistency and to remove them is not necessary. After that, you want to find pockets of corrosion and for a thorough cleaning, and only then proceed to mount directly to the insulating coating. To perform all necessary work, of course, better to turn to a specialized center of the installation. Can shine in front of the master of knowledge and to name a few brands of the best soundproofing materials. Such as "V-Block", "Noise Killer", "Dynamat" ... Although it is too much - a good center is unlikely you will be offered low-quality material. But what-proof handling car will require two or three days, remember the following. Because if you offer to make this work for the day - then everything will be done in haste, with questionable quality. Such "experts" car is better not to trust.