Burnishing

New and from a repair cars have been run in place according to the instructions of automobile manufacturers and public workshops. The duration of running is regulated by the manufacturer's instructions. If you run the first thousand miles of new or repaired car is running-moving parts, sealing gasket between the parts, and hence loosening them. Between running a new or repaired car driver should carefully monitor the work of all units and implementation of all maintenance work. During the period of running a new car driver or an authorized service must be: - do not exceed the value of the payload (not more than 70-80%) set by the manufacturer - does not exceed the vehicle manufacturer limits the speed. - Avoid heavy traffic on the roads (sand, steep climbs, deep mud, off road) - not to go with a trailer, not towing other vehicles - not to start a movement of the car with a cold engine, and not to run a cold engine with a high rate of rotation of the crankshaft; - not to replace the engine and components of vehicles, oil and grease, filled in the factory - to monitor the temperature of the brake drums. With significant heating them to regulate the braking system - monitor the temperature of wheel hubs. With a significant weakening of their heating tightening bearing hubs - monitor bracket car and pipe joints. Loose bolts and nuts to tighten immediately upon detection of a leak of oil, gasoline, water and brake fluid - to eliminate leaks. At the end of running should be: to tighten the nut cylinder head, perform the second service, change the oil in the crankcase after the washing, remove the bounding puck between the flanges of the carburetor and the intake pipe or stop screw mounted on the throttle lever to the carburetor. To ensure long and reliable operation of the car, past repair, the driver (or the official service) in the running-in period should additionally perform the following work and adhere to such basic rules: - prior to the operation of all parts of the car, the last major overhaul, spread in full accordance with the lubrication chart - check and tighten all external mounting units, assemblies and individual parts - while working to verify the degree of heating of brake drums, wheel hubs, axle and gearbox, as well as to monitor the readings of measuring and control devices - in time to replace the grease in sumps engine, gearbox, axle, steering, wash them, to replace the filter housing coarse and fine with the change of oil filter element, - meet the first service in its entirety - observe the operation of the new car in the running-in period. If the car is under warranty - that during the warranty period, all actions with the machine should be made members of the official service center. Any attempt to interfere owner of a car in the technical condition of his car may lead to the lifting of safeguards on some sites, or on the car as a whole.